PMP135 Spare Parts List Overview
The PMP135 series transmitters are widely used in industrial measurement, and their spare parts management directly affects equipment maintenance efficiency and cost. This article compiles the PMP135 spare parts list and ordering number information to help engineering technicians and procurement personnel quickly locate the required components.
Important Note: The PMP135 unit is not repairable. In case of failure, it must be replaced as a whole rather than attempting to repair internal components.
Spare Parts List and Ordering Numbers
The table below lists common PMP135 spare parts and their ordering numbers. Please match them according to the actual model and specifications.
| No. (Nr) | Ordering Number | Specifications |
|---|---|---|
| 1 | PMP135-XXXX | Standard type, 4-20mA output |
| 2 | PMP135-YYYY | With HART communication |
| 3 | PMP135-ZZZZ | Explosion-proof type, Ex ia IIC T6 |
Note: The actual ordering number may vary depending on the measuring range, process connection, and certification options. Please refer to the product selection manual.
Selection and Ordering Steps
- Confirm the complete model and ordering number of the existing PMP135 (usually located on the nameplate).
- Based on the measuring medium, pressure range, output signal, and explosion-proof requirements, filter the corresponding specifications in the spare parts list.
- If uncertain, contact the supplier with a nameplate photo or serial number to obtain the accurate ordering number.
- When placing an order, specify the quantity, delivery time, and whether a calibration certificate is required.
Maintenance and Replacement Precautions
Since the PMP135 unit is not repairable, any internal failure requires replacing the entire transmitter. This avoids accuracy degradation and safety hazards caused by on-site repair.
- Before replacement, be sure to cut off the power supply and release pressure, and comply with explosion-proof area operation regulations.
- After installing the new transmitter, zero calibration and range setting must be performed again.
- Keep the nameplate information of the old transmitter for future procurement of the same model spare parts.
It is recommended that users stock 1-2 spare parts of the same specification according to working conditions to shorten downtime.
Frequently Asked Questions (FAQ)
Can the PMP135 be repaired?
No. The PMP135 unit is not repairable and can only be replaced as a whole.
How to obtain the accurate ordering number?
Check the ordering number on the transmitter nameplate, or use the serial number to query on the manufacturer's official website. You can also contact an authorized distributor for assistance.
Does the spare parts list include all options?
This article only lists common configurations. For complete options, please refer to the latest product catalog or consult the supplier.
