FTL64 Chinese Manual Download
You can directly download the FTL64 Chinese manual to obtain complete technical specifications, installation, and operation guidelines. This manual is suitable for engineering commissioning, procurement selection, and daily maintenance reference.
Click to download FTL64 Chinese Manual.pdf
FTL64 Product Overview
FTL64 is an industrial instrument for level measurement, widely used for continuous measurement of liquids, slurries, and solid particles. Its design balances accuracy and stability, making it suitable for industries such as chemicals, water treatment, and food.
Core Features
- High-precision measurement: Adopts advanced sensing technology, with repeatability better than ±0.2%.
- Wide range ratio: Covers 0.1m to 30m, adapting to various working conditions.
- Multiple output signals: Supports 4-20mA, HART, RS485, etc.
- Protection rating IP67: Suitable for outdoor and humid environments.
Technical Parameters Overview
The following are the key technical parameters of the FTL64 for selection and procurement reference.
| Parameter | Specification |
|---|---|
| Measurement principle | Radar/Ultrasonic (depending on model) |
| Range | 0.1~30m |
| Accuracy | ±0.2% FS |
| Output signal | 4-20mA/HART/RS485 |
| Power supply | 24VDC (two-wire) |
| Process temperature | -40~+150℃ |
| Process pressure | -0.1~4MPa |
| Protection rating | IP67 |
Installation and Commissioning Steps
Correct installation and commissioning ensure long-term stable operation of the FTL64. Please follow these steps:
- Installation location selection: Avoid feed inlet, agitator, and tank wall to ensure no interference within the beam range.
- Flange or thread fixing: According to the site interface, use appropriate gaskets and tighten evenly.
- Electrical connection: Connect power and signal lines according to the wiring diagram in the manual, paying attention to polarity.
- Parameter setting: Set range, unit, and output mode via HART communicator or host computer.
- Empty tank and full tank calibration: Record the level corresponding to 4mA and 20mA respectively to complete calibration.
Common Problems and Maintenance
Measurement value fluctuation
Check for foam, steam, or agitation interference. Adjust installation position or enable damping filter.
No signal output
Confirm whether the supply voltage is within 24VDC±10%, and check wiring polarity and load resistance.
Regular maintenance recommendations
- Check antenna or probe cleanliness every 6 months.
- Calibrate output current accuracy once a year.
- Record historical fault codes for quick diagnosis.
Selection and Procurement Points
When purchasing the FTL64, please clarify medium characteristics, process temperature and pressure, output requirements, and explosion-proof rating. If an alternative model is needed, compare range and accuracy before deciding.
- Medium corrosiveness: Choose suitable wetted materials (such as PTFE, 316L).
- Explosion-proof requirements: For explosive environments, choose Ex ia/Ex d versions.
- Communication protocol: Choose HART or RS485 according to the control system.
For more details, please refer to the FTL64 Chinese manual or contact the supplier for technical support.