VEGACAP 98 Chinese Manual Download
You can directly download the VEGACAP 98 Chinese manual to obtain complete installation, commissioning, and maintenance guidance.
The downloaded file is in PDF format. It is recommended to open it with the latest version of a reader to view charts and wiring diagrams.
VEGACAP 98 Product Overview
VEGACAP 98 is a capacitive level switch used to detect the limit of liquids, solid particles, or powders. Its compact structure makes it suitable for various industrial occasions.
The instrument works based on the principle of capacitance change. When the material covers the probe, the capacitance value changes, triggering a switch signal. It is widely used in the chemical, water treatment, food, and building materials industries.
Main Technical Parameters
The table below lists the key parameters of the VEGACAP 98 for selection reference. For specific values, please refer to the latest Chinese manual.
| Parameter | Typical Value |
|---|---|
| Measuring Principle | Capacitive |
| Output Signal | Relay/Transistor/NAMUR |
| Process Connection | Thread/Flange |
| Process Temperature | -40…+200°C |
| Process Pressure | -1…+64 bar |
| Protection Rating | IP66/IP67 |
| Supply Voltage | 10…45 V DC |
Installation and Commissioning Points
Installation Precautions
- The installation position should avoid the inlet and agitator to prevent the probe from impact.
- Ensure the probe is fully inserted into the container to avoid material buildup affecting detection.
- For adhesive materials, it is recommended to choose a probe with a shielding section.
Commissioning Steps
- Confirm that the supply voltage and wiring are correct, and observe the indicator light after power-on.
- Perform zero calibration in an empty tank so that the output is in the uncovered state.
- Slowly add material until the probe is covered, and adjust the sensitivity to ensure reliable triggering.
- Repeatedly verify the switch point to ensure repeatability meets process requirements.
Selection and Maintenance Recommendations
During selection, it is necessary to clarify the process temperature, pressure, medium characteristics, and output type. For corrosive media, appropriate wetted materials should be selected.
Regularly check the probe for material buildup, wear, or insulation damage. Avoid scratching with hard objects during cleaning. If the output is abnormal, first check the wiring and power supply, then troubleshoot according to the manual.
Frequently Asked Questions
- Q: Can the VEGACAP 98 measure interface? It is usually used for limit detection; interface measurement requires special calibration.
- Q: The manual cannot be opened after download? Please confirm that a PDF reader is installed, or download it again.
- Q: How to obtain technical support? You can contact the supplier or manufacturer's customer service and provide the specific model and working conditions.
The above content is compiled based on the VEGACAP 98 Chinese manual. For actual application, please refer to the latest official documentation.