B 63-48 Chinese Manual Overview
The B 63-48 is an instrument widely used in industrial process control, and its Chinese manual is an important basis for on-site installation, commissioning, and maintenance. This article provides the official PDF download and extracts key information for quick reference by engineering technicians and procurement personnel.
Download B 63-48 Chinese Manual.pdf: Click the icon above to obtain the complete document.
Core Technology and Parameters
The B 63-48 adopts mature sensing and signal processing technology and is suitable for various industrial environments. The following are the main technical parameters for selection reference.
Main Technical Parameters Table
| Parameter Item | Specification Description |
|---|---|
| Model | B 63-48 |
| Measuring Range | See manual (depending on configuration) |
| Output Signal | 4-20mA / other options available |
| Power Supply | 24VDC (typical) |
| Accuracy Class | ±0.5% FS (reference) |
| Protection Rating | IP65 (reference) |
Product Features
- High Reliability: Industrial-grade design with strong anti-interference capability.
- Easy Installation: Standard interfaces, supporting multiple installation methods.
- Simple Maintenance: Modular structure, reducing downtime.
Installation and Commissioning Steps
Correct installation and commissioning are key to ensuring the long-term stable operation of the B 63-48. Please follow the steps below.
- Unpacking inspection: Check the model and accessories, and confirm there is no transportation damage.
- Installation location: Choose a location with low vibration and convenient observation and maintenance.
- Electrical connection: Connect the power and signal lines according to the wiring diagram in the manual, and pay attention to polarity.
- Power-on warm-up: Turn on the power; a warm-up of no less than 15 minutes is recommended.
- Parameter setting: According to process requirements, configure the range, output, etc., through the panel or software.
- Calibration verification: Use a standard signal source to perform zero and full-scale calibration.
Selection and Procurement Recommendations
When purchasing the B 63-48, the following points should be confirmed in combination with actual working conditions to avoid selection errors.
- Measuring Range: Ensure it covers the actual working interval and leaves a margin.
- Process Connection: Confirm that the thread or flange specifications match the site.
- Output Signal: Compatible with the control system interface.
- Environmental Conditions: Consider the effects of temperature, humidity, corrosiveness, etc.
- Certification Requirements: If explosion-proof or special certification is required, specify in advance.
For complete technical information, please download the B 63-48 Chinese Manual.pdf, or contact the supplier for support.